With an auto feed system, the trimmer will release more line whenever it starts to run short, based on an advanced internal system. The majority of models will have some kind of component that gauges the current length of the line and then releases more by taking advantage of the spinning taking place with the head.
Why is my Worx trimmer not working?
Check the condition of the cover, the spool and the line. If the cover or spool are broken, the head may not spin. If the line is improperly wound, the head won’t spin and the line won’t come out. Leave all motor repairs to a professional due to the high voltage contained inside the motor.
What size line does the Worx trimmer use?
Can it be used in trimmers other than Worx trimmers? The diameter of this line is approximately 0.065”. The line is pre-wound on spools specially designed to work on Worx 20V and 32V battery operated trimmers.
Why does my trimmer line keep coming out?
If this cap is broken or worn out over time, it can malfunction, causing too much line to feed out when you bump it. Depending on its damage, it could be getting hung up as it tries to return, allowing the line to continuously advance. To replace it, simply remove and replace the bump cap with a new one.
Why does my line keep breaking on my trimmer?
The most frequent cause of a line breakage is through contact with something in the garden. Usually this is the result of the cutting head being taken too close to objects, e.g. garden stones, paving edges, walls etc.
Is bump feed or auto feed better?
The automatic-feeding system draws out more line only when it reaches a certain shortness. While the bump feeder is quicker, it also uses up a lot more line, which can add up in the cost department, and the time needed to replace the line.
How long does a WORX trimmer last?
We liked it a lot and decided to get another Worx. I spoke to someone in customer service about the life of their string trimmers and was told it is about 3 years.
How do I clean my Worx trimmer?
Use a mix of water and dish detergent on the string trimmer head to clean off any grease, dirt and debris. Locate the air filter cover and remove it to make sure the air filter is clean. Replace it approximately every 90 days, based on wear and tear.
